Configuring Security Settings Of Multiple Ssids - ZyXEL Communications WAP5605 User Manual

Chapter 7 Tutorials

7.5.1 Configuring Security Settings of Multiple SSIDs

This example shows you how to configure the SSIDs with the following parameters on your
WAP5605 (in access point mode).
SSID
SSID_Worker
SSID_Guest
SSID_VoIP
Connect your computer to the LAN port of the WAP5605 using an Ethernet cable.
1
The default IP address of the WAP5605 is "192.168.1.2". In this case, your computer must have an
2
IP address in the range between "192.168.1.3" and "192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to
3
show your computer's IP address. If your computer's IP address is not in the correct range then see
Appendix C on page 135
After you've set your computer's IP address, open a web browser such as Internet Explorer and
4
type "http://192.168.1.2" as the web address in your web browser.
Enter "1234" (default) as the password and click Login.
5
Type a new password and retype it to confirm, then click Apply. Otherwise, click Ignore.
6
The Easy mode appears. Click Expert Mode in the navigation panel.
7
Go to Configuration > Network > Wireless LAN > General. Configure the screen as follows. In
8
this example, you select Enable Intra-BSS Traffic for SSID_Worker and SSID_Guest to allow
wireless clients in the same wireless network to communicate with each other. Click Apply.
62
SECURITY TYPE KEY
WPA2-PSK DoNotStealMyWirelessNet
work
WPA Compatible
Static WEP 128bit keyexample123
WPA-PSK VoIPOnly12345678
for information on changing your computer's IP address.
MAC FILTERING
Disable
Disable
Allow
00:A0:C5:01:23:45
WAP5605 User's Guide