Internet Access - ZyXEL Communications WAP5605 User Manual

• If there is no DHCP server on your network, make sure your computer's IP address is in the
same subnet as the WAP5605. See
Reset the device to its factory defaults, and try to access the WAP5605 with the default IP address.
5
See Section 11.7 on page
If the problem continues, contact the network administrator or vendor, or try one of the advanced
6
suggestions.
Advanced Suggestion
• If your computer is connected wirelessly, use a computer that is connected to a LAN port.
I can see the Login screen, but I cannot log in to the WAP5605.
Make sure you have entered the password correctly. The default password is 1234. This field is
1
case-sensitive, so make sure [Caps Lock] is not on.
This can happen when you fail to log out properly from your last session. Try logging in again after
2
5 minutes.
Disconnect and re-connect the power adaptor or cord to the WAP5605.
3
If this does not work, you have to reset the device to its factory defaults. See
4
104.

12.3 Internet Access

I cannot access the Internet.
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
1
Start Guide.
Make sure the WAP5605 in access point mode is connected to a broadband modem or router with
2
Internet access. Connect to another WAP5605 in client mode to access the Internet through the
WAP5605 in access point mode. Use the switch on the WAP5605's side panel to change your system
operating mode setting (see
transmission range of the AP.
If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless
3
client are the same as the settings in the AP.
Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again.
4
If the problem continues, contact your ISP.
5
WAP5605 User's Guide
Appendix B on page
98.
Section 2.1.2.1 on page
Chapter 12 Troubleshooting
125.
Section 12.4 on page
21). Make sure the client is within the
103