Access Point Mode; Chapter 4 Access Point Mode; Overview; What You Can Do - ZyXEL Communications WAP5605 User Manual

4.1 Overview

The WAP5605 is set to access point mode by default. In this mode your WAP5605 bridges a wired
network (LAN) and wireless LAN (WLAN) in the same subnet. See the figure below for an example.
Figure 14 Wireless Internet Access in Access Point Mode
Note: See Chapter 7 on page 55

Access Point mode.

4.2 What You Can Do

• Use the Status screen
WAP5605.
• Use the LAN screen
an access point.
• Use the Wireless LAN screens
wireless security between the wireless clients and the WAP5605.
WAP5605 User's Guide
C
WLAN
for an example of setting up a wireless network in
(Section 4.4 on page 33) to view read-only information about your
(Chapter 10 on page 89) to set the IP address for your WAP5605 acting as
(Chapter 9 on page
H A PT ER
Access Point Mode
LAN
75) to configure the wireless settings and
4
31