Connecting The Wap5605 (In Client Mode) To An Ap - ZyXEL Communications WAP5605 User Manual

Chapter 7 Tutorials
11 Select SSID_VoIP from the SSID drop-down list. Configure the screen as follows. Click Apply.
12 Click the MAC Filter tab to configure MAC filtering for the SSID_VoIP wireless network. Select
SSID_VoIP from the SSID drop-down list and select Allow in the Policy field. Enter the VoIP
device's MAC address in the Add a station Mac Address field and click Apply to allow only the
VoIP device to associate with the WAP5605 using this SSID.

7.6 Connecting the WAP5605 (in Client Mode) to an AP

If you have an access point with Internet access deployed in your network already, and you want to
use the WAP5605 as a wireless client to connect to the existing AP, set the WAP5605 to client mode.
The WAP5605 then acts as a wireless client. Your device, such as a computer, can connect to the
WAP5605 through a wired connection to access the Internet.
Connect your computer to the LAN port of the WAP5605 using an Ethernet cable.
1
The default IP address of the WAP5605 in client mode is "192.168.1.10". In this case, your
2
computer must have an IP address in the range between "192.168.1.11" and "192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to
3
show your computer's IP address. If your computer's IP address is not in the correct range then see
Appendix C on page 135
64
for information on changing your computer's IP address.
WAP5605 User's Guide