Resetting The Wap5605 To Its Factory Defaults - ZyXEL Communications WAP5605 User Manual

Chapter 12 Troubleshooting
I cannot access the Internet anymore. I had access to the Internet (with the WAP5605), but
my Internet connection is not available anymore.
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
1
Start Guide and
Reboot the WAP5605.
2
If the problem continues, contact your ISP.
3
The Internet connection is slow or intermittent.
There might be a lot of traffic on the network. Look at the LEDs, and check
1
If the WAP5605 is sending or receiving a lot of information, try closing some programs that use the
Internet, especially peer-to-peer applications.
Check the signal strength. If the signal strength is low, try moving the clients closer to the AP if
2
possible, and look around to see if there are any devices that might be interfering with the wireless
network (for example, microwaves, other wireless networks, and so on).
Reboot the WAP5605.
3
If the problem continues, contact the network administrator or vendor, or try one of the advanced
4
suggestions.
Advanced Suggestions
• Check the settings for QoS. If it is disabled, you might consider activating it.

12.4 Resetting the WAP5605 to Its Factory Defaults

If you reset the WAP5605, you lose all of the changes you have made. The WAP5605 re-loads its
default settings, and the password resets to 1234. You have to make all of your changes again.
You will lose all of your changes when you push the RESET button.
To reset the WAP5605,
Make sure the power LED is on.
1
Press the RESET button for longer than 1 second to restart/reboot the WAP5605.
2
104
Section 1.6 on page 17.
Section 1.6 on page 17.
WAP5605 User's Guide