Resetting The Wap5605; Procedure To Use The Reset Button; The Wps Button - ZyXEL Communications WAP5605 User Manual

1.5 Resetting the WAP5605

If you forget your password or IP address, or you cannot access the Web Configurator, you will need
to use the RESET button at the back of the WAP5605 to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously saved, the password
will be reset to "1234" and the IP address of the WAP5605 in AP mode will be reset to
"192.168.1.2" and the IP address of the WAP5605 in client mode will be reset to "192.168.1.10".

1.5.1 Procedure to Use the Reset Button

Make sure the power LED is on.
1
Press the RESET button for longer than 1 second to restart/reboot the WAP5605.
2
Press the RESET button for longer than five seconds to set the WAP5605 back to its factory-default
3
configurations.

1.6 The WPS Button

You can use the WPS button (
quickly set up a wireless network with strong security.
Make sure the POWER LED is on (not blinking).
1
Press the WPS button for more than three seconds and release it. Press the WPS button on another
2
WPS-enabled device within range of the WAP5605.
Note: You must activate WPS in the WAP5605 that acts as the AP and in another
WAP5605 that acts as the client within two minutes of each other.
WAP5605 User's Guide
) on the front panel of the WAP5605 to activate WPS in order to
Chapter 1 Getting to Know Your WAP5605
17