Wps Screen - ZyXEL Communications WAP5605 User Manual

5.8 WPS Screen

Use this screen to enable Wi-Fi Protected Setup (WPS) on the WAP5605. Go to Configuration >
Wireless LAN > WPS to open the following screen.
Figure 25 Client Mode: WLAN > WPS
The following table describes the labels in this screen.
Table 17 Client Mode: WLAN > WPS
LABEL
Station Site Survey
No.
SSID
BSSID
Signal Strength
Ch.
Auth.
Encrypt
Ver.
Status
PIN
PIN Start
PBC Start
Rescan
WAP5605 User's Guide
DESCRIPTION
Use the radio button to select the wireless device to which you want to connect
using WPS.
This displays the SSID of the wireless device.
This displays the MAC address of the wireless device.
This displays the strength of the wireless signal. The signal strength mainly
depends on the antenna output power and the distance between your WAP5605
and this device.
This displays the channel number used by this wireless device.
This displays the authentication method used by this wireless device.
This displays the data encryption method used by this wireless device.
This displays the firmware version running on the wireless device.
This displays Conf. (configured) when WPS has been set up on the wireless
device.
This displays Unconf. (unconfigured) if WPS has not been set up on the wireless
device.
This displays the PIN number of the WAP5605.
Click this button to perform wireless security information synchronization using
the PIN configuration method.
Click this button to perform wireless security information synchronization using
the Push Button Configuration (PBC) method.
Click this button to search for available for WPS-enabled devices within
transmission range and update this table.
Chapter 5 Client Mode
47