The Web Configurator; Overview; Accessing The Web Configurator - ZyXEL Communications WAP5605 User Manual

6.1 Overview

This chapter describes how to access the WAP5605 Web Configurator and provides an overview of
its screens.
The Web Configurator is an HTML-based management interface that allows easy setup and
management of the WAP5605 via Internet browser. Use Internet Explorer 6.0 and later or Firefox
2.0 and later versions. The recommended screen resolution is 1024 by 768 pixels.
In order to use the Web Configurator you need to allow:
• Web browser pop-up windows from your device. Web pop-up blocking is enabled by default in
Windows XP SP (Service Pack) 2.
• JavaScripts (enabled by default).
• Java permissions (enabled by default).
Refer to the Troubleshooting chapter
functions are allowed in Internet Explorer.

6.2 Accessing the Web Configurator

Connect your computer to the LAN port of the WAP5605.
1
The default IP address of the WAP5605 in access point mode is "192.168.1.2". In this case, your
2
computer must have an IP address in the range between "192.168.1.3" and "192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to
3
show your computer's IP address. If your computer's IP address is not in the correct range then see
Appendix C on page 135
After you've set your computer's IP address, open a web browser such as Internet Explorer and
4
type "http://192.168.1.2" as the web address in your web browser.
WAP5605 User's Guide
C

The Web Configurator

(Chapter 12 on page
for information on changing your computer's IP address.
H A PT ER
101) to see how to make sure these
6
49