Wps Station Screen - ZyXEL Communications WAP5605 User Manual

Chapter 9 Wireless LAN
Table 34 Network > Wireless LAN > WPS
LABEL
Status
Release
Configuration
802.11 Mode
SSID
Security
Apply
Cancel

9.10 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Note: After you click Push Button on this screen, you have to press a similar button in
the wireless station utility within 2 minutes. To add the second wireless station, you
have to press these buttons on both device and the wireless station again after the
first 2 minutes.
Figure 51 Network > Wireless LAN > WPS Station
86
DESCRIPTION
This displays Configured when the WAP5605 has connected to a wireless network using
WPS or when Enable WPS is selected and wireless or wireless security settings have
been changed. The current wireless and wireless security settings also appear in the
screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless
security changes on the WAP5605 or you click Release_Configuration to remove the
configured wireless and wireless security settings.
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the WAP5605.
This is the 802.11 mode used. Only compliant WLAN devices can associate with the
WAP5605.
This is the name of the wireless network (the WAP5605's first SSID).
This is the type of wireless security employed by the network.
Click Apply to save your changes back to the WAP5605.
Click Cancel to reload the previous configuration for this screen.
WAP5605 User's Guide