ZyXEL Communications WAP5605 User Manual page 19

The following table describes the LEDs and the WPS button.
Table 1 Front Panel LEDs and WPS Button
LED
Quality
Wireless
LAN 1-2
Power
WPS
WAP5605 User's Guide
COLOR STATUS DESCRIPTION
Green On AP mode: This LED is always on after the system starts up.
Client mode: The WAP5605 is connecting to an AP and the
transmission rate is 65 Mbps or above.
Amber On Client mode: The WAP5605 is connecting to an AP and the
transmission rate is between 65 Mbps and 19.5 Mbps.
Red On Client mode: The WAP5605 is connecting to an AP and the
transmission rate is below 19.5 Mbps.
Off AP mode: The WAP5605 is not receiving power.
Client mode: The WAP5605 is not receiving power or not
associating with an AP.
Green On The WAP5605 is ready, but is not sending/receiving data
through the wireless LAN.
Blinking The WAP5605 is sending/receiving data through the wireless
LAN.
Off The wireless LAN is not ready or has failed.
Green On The WAP5605 has a successful 10/100/1000 Mbps Ethernet
connection.
Blinking The WAP5605 is sending/receiving data through the LAN.
Off The LAN is not connected.
Green On The WAP5605 is receiving power and functioning properly.
Off The WAP5605 is not receiving power.
Blue On WPS is enabled.
Blinking The WAP5605 is negotiating a WPS connection with a wireless
(slow) device.
Blinking The WPS negotiation failed.
(fast)
Off The wireless LAN is not ready or has failed.
Chapter 1 Getting to Know Your WAP5605
19