Removing Input Bevel Pinion - BMW R 1150 GS Repair Manual

h
120

Removing input bevel pinion

•
Press out splined section of shaft.
•
If necessary, remove/install circlip.
33.6
2
1
120 h
4
33 1 510
•
Bolt the rear wheel drive to the retaining fixture,
BMW No. 33 1 510/511.
•
Bolt the locking arm (1) to the retaining fixture.
•
Tighten grub screws until they are seated.
e
Caution:
The grub screws must not project, or the neck of the
housing could be damaged.
•
Screw threaded bushings (2) down on to the rear
wheel drive and secure them with the wheel
studs.
•
Heat hex nut (3) at the input bevel pinion to
100 °C (212 °F) and unscrew with w/f 36 socket
wrench insert and reduction adapter,
BMW No. 33 1 720.
L
Note:
S330020
If necessary, use cross-handle with two tubular ex-
tensions.
•
Heat the housing to max. 120 °C (248 °F) and un-
screw threaded ring (4) with pin wrench,
BMW No. 33 1 700.
•
To remove the input bevel pinion (5), remove the
crown wheel.
............................ See "Removing crown wheel"
a
33 1 720
100 h
3
33 1 700
5
S330030