Removing and installing front brake
disc
•
Remove screws securing the brake caliper.
•
Remove front wheel.
•
Remove and install brake discs.
•
Degrease brake discs before installing.
L
Note:
Installed direction (arrow) of brake discs must be
correct.
X
Tightening torque:
Brake disc to front wheel
(clean thread + Loctite 243).......................... 24 Nm
e
Caution:
Check and, if necessary, adjust sensor gap, if com-
ponents have been replaced apply mark to indicate
point where gap is largest.
Sensor gap:...... 0.45...0.55 mm (0.018 ... 0.022 in)
R21360010
34.9