1
Installing gearbox housing
•
Install the dowel pins in cover and in housing, but
do not drive the pins fully home.
•
Install breather tube (1) in housing cover.
e
Caution:
Clean and de-grease the sealing faces.
The sealing compound sets within 30 minutes; with-
in this time, place the housing in position and screw
it down.
•
Apply Loctite 574 sealing compound to the mat-
ing face of the cover.
•
Place assembly sleeve, BMW No. 23 4 732, on
the output shaft.
•
Place assembly sleeve, BMW No. 23 4 612, on
the selector shaft.
23.26
•
Heat the bearing seats in the housing to
80 ... 100 °C (176 ... 212 °F) and place the hous-
ing on the cover.
23 4 732
23 4 612
R21230140
h
80 ...100
R21230030