1
3
Removing and installing rear ABS
sensor
•
Before removing/installing, clean the sensor
bore.
•
Using Torx T 25, slacken sensor (1).
•
Disconnect plug (2) of sensor cable.
•
Installation is the reverse of the removal proce-
dure.
•
Coat O-rings with oil before installing.
e
Caution:
Route the sensor cable correctly.
Check sensor gap and adjust if necessary with
shims (3).
Sensor gap:...... 0.45...0.55 mm (0.018 ... 0.022 in)
X
Tightening torque:
Sensor ...........................................handtight, 4 Nm
2
R21340020
34.13