Removing Needle Roller Bearing For Input Bevel Pinion; Installing Needle Roller Bearing For Input Bevel Pinion; Assembling Input Bevel Pinion - BMW R 1150 GS Repair Manual

Removing needle roller bearing for input bevel
pinion
00 8 575
00 8 573
•
Heat the housing to 120 °C (248 °F).
•
Remove the outer ring of the needle roller bear-
ing using internal puller, BMW No. 00 8 573,
threaded extension, BMW No. 00 8 575, and
counter-support, BMW No. 00 8 572.
Installing needle roller bearing for input bevel
pinion
•
Heat the needle roller bearing seat to 100 °C
(212°F).
•
Press in needle roller bearing using drift or the in-
put bevel pinion.
33.8
2
1
h
100

Assembling input bevel pinion

•
Clean the threads of the input bevel pinion.
•
Heat the inner race (1) to 100 °C (212°F) and
push onto input bevel pinion (2) as far as the
stop.
•
Push the outer race (3) together with the roller
cage (4) on to the inner race.
00 8 572 •
Heat ball thrust bearing (5) to 100 °C (212°F) and
push fully on to input bevel pinion.
•
Allow input bevel pinion to cool down.
S330050
3
4
5
h
100
KR330131