46 5 620
2
Installing auxiliary frame
(Raising frame unit clear of engine)
•
Remove rear wheel.
•
Remove height adjuster from seat on right.
•
Remove hydraulic spring-strut adjuster.
•
Remove rear spring strut.
•
Install the rear wheel.
•
Remove the upper securing screw and the bot-
tom bolt of the engine/frame connecting strut (1).
•
Place auxiliary frame, BMW No. 46 5 630, in po-
sition and secure to the rear spring-strut
mount (2).
•
Engage the auxiliary frame to the front anchorage
point for the fuel tank (3).
e
Caution:
Use adhesive tape to mask the fuel tank anchorage
and protect it against scratches.
•
Align the auxiliary frame with the flat of the fuel-
tank anchorage, install the threaded bushings (4)
at the connecting struts/frame and tighten.
•
Remove front fasteners for rear frame (5) on left
and right.
•
Install adapter (6) in link/rear-frame anchorage
and secure to auxiliary frame.
•
Remove the fastener securing the front spring
strut at the bottom.
•
Press leading link down at front (arrow), or pull
tail section down.
1
6
5
8
•
Remove bolt (7) securing the frame to the en-
gine.
•
Secure the front spring strut at the bottom.
•
Slightly raise the frame unit at the front and re-
move the fasteners securing the clutch slave
cylinder.
•
Raise the frame unit at the front.
e
Caution:
When raising the frame unit, take care not to
damage the oil line on the engine at the front.
•
Remove the gearbox, swinging arm, rear axle
and rear wheel together.
4
3
7
RS111010
11.17