Removing and installing battery
holder
•
Remove fuel tank.
•
Remove the battery.
e
Caution:
Disconnect the negative battery terminal first, then
the positive terminal.
Connect the positive battery terminal first, then the
negative terminal.
•
Remove Motronic control unit.
•
[ABS] Remove the unit.
•
Remove the air intake stub pipe.
•
Disconnect Bowden cable for starting-speed in-
crease from handlebar fitting.
•
Disconnect cable from left throttle valve.
•
Remove Bowden-cable divider from holder.
•
Pull the battery holder to the left to remove.
•
Installation is the reverse of the removal proce-
dure.
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
RS610010
61.17