Removing auxiliary frame
(Lowering frame unit onto engine)
•
Lower the frame unit into position from front.
e
Caution:
Make sure that all components are correctly posi-
tioned. Do not damage cables, lines and Bowden
cables.
•
Install the clutch slave cylinder.
•
Lightly grease the shaft of the leading link, insert
it from the left and tighten.
•
Remove the fastener securing the front spring
strut at the bottom.
•
Press leading link down at front, or pull tail sec-
tion down.
e
Caution:
If necessary, mask off the leading link to prevent it
from being scratched.
•
Insert pin, BMW No. 46 5 630, from the left to
align the front frame bores with the correspond-
ing bores in the engine, insert the bolts from the
right and tighten.
•
Secure the front spring strut at the bottom.
•
Remove the auxiliary frame.
11.18