Installing Right Cylinder Head - BMW R 1150 GS Repair Manual

Installing right cylinder head

Adjustment specification
e
Caution:
When assembling, always start with the right-hand
cylinder.
Right cylinder = at firing TDC:
marks (arrows) on chainwheel/auxiliary shaft and
chain sprocket/crankshaft are aligned.
•
Lock engine at firing TDC by inserting pin,
BMW No. 11 2 650, through holes in clutch
housing and engine block.
L
Note:
With engine installed, set engine to TDC with dial
gauge holder, BMW No. 00 2 650, and dial gauge,
BMW No. 00 2 510.
Right cylinder = at firing TDC:
Locating pin (arrow) on right camshaft sprocket is at
bottom.
Mark (arrow) and tip of tooth on right camshaft gear
are exactly aligned with mark X on valve gear car-
rier.
•
Recheck setting with timing chain tensioner in-
stalled.
11.58
X
S110120
S110140