Oil Pump - Ford 1997 Aerostar Workshop Manual

1997 Aerostar/Ranger
Section 03-01B: Engine, 3.0L V-6
IN-VEHICLE SERVICE

Oil Pump

Removal
1. Remove oil pan (6675) as outlined.
2. Remove retaining bolt and remove oil pump and intermediate shaft.
Installation
1. NOTE: If replacing oil pump make sure to remove oil pump intermediate shaft (6A618) from oil
pump.
If replacing oil pump (6600), insert oil pump intermediate shaft assembly into hex drive hole in oil
pump until oil pump intermediate shaft retaining ring (6629) "clicks" into place.
2. Install oil pump with oil pump intermediate shaft through intermediate shaft hole in rear main bearing
cap. Position oil pump over locating pins.
3. Install retaining bolt and tighten to 40-55 Nm (30-40 lb-ft).
4. Install oil pan as outlined.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B27.HTM~gen~ref.HTM
1997 Aerostar, Ranger Workshop Manual
tomsn048@gmail.com
Page 1 of 1
2011-04-27