Ford 1997 Aerostar Workshop Manual page 124

1997 Aerostar/Ranger
43. Connect electrical connector to power steering pressure switch (PSP switch).
44. Reconnect heater water supply and return hoses.
45. CAUTION: Fan clutch nut has left hand thread. Turn counterclockwise to tighten.
Install assembled fan blade and clutch and tighten to 41-135 Nm (30-100 lb-ft) using Fan Clutch
Holding Tool T84T-6312-C and Fan Clutch Nut Wrench T84T-6312-D.
46. Install fan shroud over fan blade.
47. Install radiator (8005) by positioning 2 lower guide pins in grommets and securing at top with 2
retaining bolts. Tighten bolts to 17-27 Nm (13-20 lb-ft).
48. Reconnect transmission oil cooler lines to fittings in left radiator tank. Tighten cooling line flair nuts to
22-30 Nm (16-22 lb-ft).
49. Position fan shroud in retaining clips at bottom and secure with 2 bolts at top. Tighten screws to 6-8
Nm (53-71 lb-in).
Radiator Installation, Aerostar 3.0L
Part
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B39.HTM~gen~ref.HTM
tomsn048@gmail.com
Page 15 of 18
2011-04-27