Ford 1997 Aerostar Workshop Manual page 137

1997 Aerostar/Ranger
37. Remove the protective caps and connect the automatic transmission oil cooling lines to the radiator
connectors. Tighten to 20 Nm (15 lb-ft).
38. NOTE: The fan clutch has left-hand threads, so it must be turned counterclockwise for
installation and tightening.
Position the accessory drive belt over the front of the engine. Carefully lower the fan shroud and the
fan and clutch assembly into the vehicle. Using Strap Wrench D85L-6000A or equivalent, install the
fan clutch assembly. Tighten the fan to 53 Nm (39 lb-ft).
39. Position the fan shroud into the lower retainers and install the upper retaining bolts. Tighten to 7 Nm
(62 lb-in).
40. Install the accessory drive belt.
Item Part Number
1 3F671
2 19D629
3 3D673
4 6B209
5 6312
6 8A528
7 10300
41. Install the radiator overflow hose to the radiator. Install the upper radiator hose and position the
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B40.HTM~gen~ref.HTM
Description
Belt Idler Pulley
A/C Compressor
Power Steering Pump Pulley
Drive Belt Tensioner
Crankshaft Pulley
Water Pump Pulley
Generator
tomsn048@gmail.com
Page 10 of 12
2011-04-27