Ford 1997 Aerostar Workshop Manual page 120

1997 Aerostar/Ranger
21. Position a 22mm socket and breaker bar on crankshaft damper bolt. Rotate crankshaft (6303)
clockwise (as viewed from front) to gain access to each of the torque converter studs. Install a nut on
each stud and tighten to 27-46 Nm (20-34 lb-ft).
22. Install converter housing lower cover to converter housing and tighten to 16-22 Nm (12-16 lb-ft).
23. Install starter to transmission. Install dash panel ground cable and starter ground strap. Tighten
starter bolts to 21-27 Nm (15-20 lb-ft). Connect starter relay cable and tighten nut and washer.
24. Position shifter cable in shifter cable bracket on transmission case. Press end of cable on ball stud on
lower portion of manual valve detent lever. Refer to
25. Install kickdown control cable in bracket and press end of cable on ball stud.
26. Connect neutral/start switch and converter clutch solenoid wiring connectors.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B39.HTM~gen~ref.HTM
Section 07-05
tomsn048@gmail.com
Page 11 of 18
to adjust shifter cable.
2011-04-27