Ford 1997 Aerostar Workshop Manual page 62

1997 Aerostar/Ranger
25. CAUTION: Rocker arm fulcrum must be fully seated into cylinder head and push rod
must be fully seated into lifter sockets before final tightening.
Final-tighten allrocker arm bolts (6A527) to 26-38 Nm (19-28 lb-ft) with camshaft in any position.
26. Installengine front cover including oil pan (6675), crankshaft vibration damper and front accessory
components as outlined in this section for Aerostar or Ranger.
27. On Ranger vehicles, position the air conditioning hose and manifold assembly in engine compartment
with hoses as originally routed with no kinks or binds.
28. Remove all caps and plugs. Push suction hose into coupling on accumulator and liquid line into
coupling on condenser.
29. Position hose assembly manifold to A/C compressor and install retaining bolt. Tighten to 25-30 Nm
(18-22 lb-ft).
30. Evacuate and recharge air conditioning system as outlined in
31. Install valve covers as outlined in this section.
32. Install fuel injector electrical harness to each injector. Secure with standoffs to inboard rocker arm
cover studs.
33. Install throttle body (9E926) as outlined in
34. Install ignition coil and bracket assembly (Ranger only). Tighten retaining nuts to 16-20 Nm (12-15 lb-
ft).
35. Position the EGR tube in the EGR valve and start the first few threads of the flare nut. Install the bolt
at the exhaust manifold end and tighten to 20-30 Nm (15-22 lb-ft). Tighten the flare nut to 35-65 Nm
(26-48 lb-ft).
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B23.HTM~gen~ref.HTM
Section 12-00
Section 03-04B .
tomsn048@gmail.com
Page 7 of 10
.
2011-04-27