Ford 1997 Aerostar Workshop Manual page 166

1997 Aerostar/Ranger
45. If a new camshaft position sensor, pour the rest of the pint of Engine Assembly Lubricant D9AZ-
19579-D or equivalent meeting Ford specification ESR-M99C80-A through distributor hole onto cam
drive gear.
46. Install camshaft position sensor. Refer to
timing.
47. Install crankshaft vibration damper using Vibration Damper and Seal Replacer T82L-6316-A and
Front Cover Seal Installer T70P-6B070-A. Tighten crankshaft pulley bolt (6A340) to 125-165 Nm (92-
122 lb-ft).
48. Connect spark plug wire set (12281) to the spark plugs.
49. Install the following PCV system components:
Positive crankcase ventilation valve (PCV valve) (6A666) and crankcase ventilation grommet.
PCV closure hose.
Oil filler cap (Ranger).
50. Install oil filler cap. Note the location of the oil dipstick tube support bracket. Tighten exhaust manifold
attaching bolts to 20-30 Nm (15-22 lb-ft).
51. Install flywheel. Tighten the attaching bolts to 73-87 Nm (54-64 lb-ft) in the standard cross-tightening
sequence.
PCV System Components, Installation, Ranger
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B43.HTM~gen~ref.HTM
Section 03-14 , Engine Controls, Electronic, for fuel injection
tomsn048@gmail.com
Page 22 of 23
2011-04-27