Ford 1997 Aerostar Workshop Manual page 47

1997 Aerostar/Ranger
S309
4 3A733
5 6B209
6 N606068-
S309
7 3F671
A —
B —
C —
6. Remove 4 screws retaining crankshaft pulley (6312) and remove pulley.
7. Remove bolt and washer retaining crankshaft damper to crankshaft.
8. Remove crankshaft vibration damper from crankshaft (6303) using Crankshaft Damper Remover
T58P-6316-D and Damper Remover Adapter T82L-6316-B.
9. Drain engine oil from crankcase.
10. Remove oil pan (6675) as outlined in this section and discard oil pan gasket (6710).
11. Lower vehicle.
Fastener Location, Water Pump Front Cover
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B21.HTM~gen~ref.HTM
Power Steering Pump Pulley
Drive Belt Tensioner
Bolt
Power Steering Belt Idler Support
Tighten to 40-55 Nm
(30-41 Lb-Ft)
Pulley with Pull-Off Groove Facing Front, Flush with
End of Shaft + /- .25mm
(0.018 Inch)
Tighten to 30-50 Nm
(22-37 Lb-Ft)
tomsn048@gmail.com
Page 5 of 10
2011-04-27