Ford 1997 Aerostar Workshop Manual page 64

1997 Aerostar/Ranger
38. Install fuel line safety clips.
39. Connect vacuum lines to premarked locations.
40. Connect electrical connections of:
Intake air temperature sensor (IAT sensor) (12A697)
Idle air control valve (IAC valve) (9F715)
Engine coolant temperature sensor (ECT sensor) (12A648)
Camshaft position sensor
Ignition coil
Radio ignition interference capacitor (18801)
Water temperature indicator sender unit (10884)
EGR pressure sensor, if equipped
EGR vacuum regulator control, if equipped
Refer to Section 18-01 for further information.
41. Fill and bleed cooling system with specified coolant and proper mixture.
42. Fill crankcase with specified amount and viscosity of oil.
43. Install air cleaner outlet tube to throttle body and MAF sensor (12B579) . Tighten retaining clamps to
1.9 Nm (16 lb-in).
44. Install closure hose to valve cover and air cleaner outlet tube provisions.
45. NOTE: When the battery has been disconnected and reconnected, some abnormal drive
symptoms may occur while thepowertrain control module (PCM) (12A650) relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
Connect ground cable at battery.
46. Start engine and check for coolant, oil, fuel and vacuum leaks.
47. Verify and correct default base initial engine timing to 10 degrees BTDC. Refer to the Powertrain
Control/Emissions Diagnosis Manual. Tighten retaining bolt to 24 Nm (18 lb-ft).
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B23.HTM~gen~ref.HTM
tomsn048@gmail.com
Page 9 of 10
2011-04-27