Ford 1997 Aerostar Workshop Manual page 59

1997 Aerostar/Ranger
17. Completely coat camshaft position sensor gear teeth with Engine Assembly Lubricant D9AZ-19579-D
or equivalent meeting Ford specification ESR-M99C80-A.
18. CAUTION: If a new camshaft is installed, always add the rest of the pint of Engine
Assembly Lubricant D9AZ-19579-D or equivalent meeting Ford specification ESR-M99C80-A to
the engine oil by pouring it through the distributor hole onto the camshaft drive gear. Run
engine at idle for five minutes before driving vehicle.
Install camshaft position sensor. Refer to
19. Rotate engine socamshaft is in Position A, as shown, with camshaft sprocket timing mark and
crankshaft sprocket timing mark at top center.
20. NOTE: Lubricate each push rod, rocker arm, and rocker arm fulcrum with Engine Assembly
Lubricant D9AZ-19579-D or equivalent meeting Ford specification ESR-M99C80-A before
installing.
Install push rod, rocker arm, rocker arm fulcrum, and rocker arm bolt for valves:
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B23.HTM~gen~ref.HTM
Section 03-14 .
tomsn048@gmail.com
Page 4 of 10
2011-04-27