Ford 1997 Aerostar Workshop Manual page 128

1997 Aerostar/Ranger
Section 03-01B: Engine, 3.0L V-6
REMOVAL AND INSTALLATION
3.0L Engine, Ranger
SPECIAL SERVICE TOOL(S) REQUIRED
Description
Fan Clutch Holding Tool
Fan Clutch Nut Wrench
Clutch Coupling Tool
Strap Wrench
Fuel Pressure Gauge
Spring Lock Coupling Disconnect Tool (3/8 inch) T81P-19623- G1
Spring Lock Coupling Disconnect Tool (1/2 inch) T81P-19623- G2
Spring Lock Coupling Disconnect Tool (5/8 inch) T83P-19623-C
Spring Lock Coupling Disconnect Tool (3/4 inch) T85L-19623-A
Spreader Bar
Teflon® Seal Replacer Set
Removal
1. Disconnect the negative battery cable. Refer to
2. Drain the cooling system. Refer to
3. Discharge and recover the refrigerant from the A/C system. Refer to
4. Drain the power steering fluid.
5. Disconnect the hood light connector and locator from the hood. Unclip the ground strap from the right
side of the hood. Mark the location of the hood hinges, remove the four bolts, and remove the hood.
6. Disconnect the crankcase ventilation hose from the air cleaner outlet tube. Disconnect the electrical
connectors from the mass air flow (MAF) sensor and the intake air temperature (IAT) sensor.
Disconnect the harness locator from the air cleaner outlet tube. Loosen the clamp at the throttle body,
unsnap the air cleaner cover from the air cleaner housing. Remove the air cleaner cover and air
cleaner outlet tube as an assembly.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B40.HTM~gen~ref.HTM
1997 Aerostar, Ranger Workshop Manual
Tool Number
T84T-6312-C
T84T-6312-C
T88T-70522-A
D85L-6000-A
T80L-9974-B
D93P-6001-A3
D90P-3517-A
Section 14-01
Section 03-03 .
tomsn048@gmail.com
.
Section 12-03A .
Page 1 of 12
2011-04-27