Ford 1997 Aerostar Workshop Manual page 51

1997 Aerostar/Ranger
8
9
10
11
12
13
14
15
a
Apply Pipe Sealant with Teflon D8AZ-19554-A or equivalent meeting Ford specifications WSK-
M2G350-AZ and ESR-M18P7-A to fastener threads.
4. Install engine front cover and attaching bolts. Refer to the previous illustration. Tighten bolts 1 through
10 to 20-30 Nm (15-22 lb-ft) and bolts 11 through 15 to 8-12 Nm (6-8 lb-ft).
5. Raise vehicle.
6. Install oil pan as outlined in this section.
7. Coat crankshaft vibration damper sealing surface with clean engine oil. Apply RTV or equivalent
meeting Ford specification ESE-M4G195-B, using Rotunda RTV Dispenser 021-00031, to keyway of
damper prior to installation. Install damper using Damper/Front Cover Seal Installer T82L-6316-A.
Install crankshaft pulley bolt (6A340) and crankshaft pulley retaining washer (6378) and torque to
125-165 Nm (94-123 lb-ft).
8. Install crankshaft pulley and torque 4 screws to 53-70 Nm (40-52 lb-ft).
9. On Aerostar only, position A/C compressor bracket over 2 engine front cover studs and install 2 nuts
on engine front cover studs and 3 screws into engine block bosses. Torque all A/C compressor
bracket retainers to 41-54 Nm (31-40 lb-ft).
10. Detach A/C compressor from sidemember of engine compartment and secure to A/C compressor
bracket with 4 screws. Torque fasteners to 22-28 Nm (17-21 lb-ft).
11. Lower vehicle.
12. Install water pump as outlined in this section (if removed).
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B21.HTM~gen~ref.HTM
N804811- S8 M8 x 1.25 x 73.0 20- 30 15- 22
N804811- S8 M8 x 1.25 x 70.0 20- 30 15- 22
N606543- S2 M8 x 1.25 x 52.0 20- 30 15- 22
N804576- S8 M6 x 1.0 x 28.5
N804576- S8 M6 x 1.0 x 28.5
N804576- S8 M6 x 1.0 x 28.5
N804576- S8 M6 x 1.0 x 28.5
N804576- S8 M6 x 1.0 x 28.5
tomsn048@gmail.com
8-12 6-8
8-12 6-8
8-12 6-8
8-12 6-8
8-12 6-8
Page 9 of 10
2011-04-27