Replacing Slow-Blow Fuses - Kubota RTV400 Operator's Manual

C Protected circuit
Fuse Capacity
No. (A)
1 15 Head lamp, Tail lamp, Panel
2 10
3 5
4 ---
5 15
6 10 Regulator, (Work light relay), (AUX (KEY ON))
7 5
8 10
9 15
10 15
11 ---
12 5, 10, 15
Protected circuit (OLD)
Eng. control, Fuel pump
Starter
---
(Hazard)
Panel
12V DC output
Brake lamp, Horn
(Work light)
Fuse puller
Spare
BReplacing Slow-Blow Fuses
The slow-blow fuses are intended to protect the electrical
cabling. If any of them have blown out, be sure to pinpoint
the cause. Never use any substitute, use only a KUBOTA
genuine part.
C Replacement procedure
1. Disconnect the negative cable of the battery.
2. Remove the cover and the slow-blow fuse box cover.
3. Pull out the slow-blow fuse.
4. Insert a new slow-blow fuse into the slow-blow fuse
box.
5. Install the slow-blow fuse box cover.
6. Connect the negative battery cable.
(1) Slow-blow fuse box
C Protected circuit
Fuse No. Capacity (A)
1 Slow-blow fuse (30)
2 Slow-blow fuse (50)
PERIODIC SERVICE
Protected circuit
Key switch
Regulator
63