Setting Unconfigured Mode; Dip Switch Settings - 3Com OfficeConnect 3CR414492 Getting Started Manual

3com officeconnect 3cr414492: user guide
Table of Contents

Advertisement

1-8
C
HAPTER




Setting Unconfigured Mode

Use this versatile mode if you want to boot the unit
without any configuration. You can manually configure the
unit to operate in any way, including Bridge Mode or DHCP
Smart Mode.
1 Set all switches to OFF to boot your unit in Unconfigured
Mode.
2 You must set all of the configuration parameters. This
allows you complete flexibility with your configuration.

DIP Switch Settings

The Dual Inline Package (DIP) switch settings initialize the
OCR 812 with pre-configured parameters. The
corresponding Boot Mode options are as follows:
Table 1-2 DIP Settings
1
off
off
off
off
on
off
on position = set ADSL to ANSI mode
off position = set ADSL to Multimode
Your service provider gives you the VPI/VCI settings, but if
you want to change them, go to the Remote Site
1: G
S
ETTING
TARTED
A remote site profile named "bridge" is set up to bridge
all traffic with RFC 1483 encapsulation on the specified
VPI/VCI.
Spanning Tree Disabled
Administrative Login profile: User Name: root and
Password:!root
2
3
on
off
off
on
off
off
off
off
off
off
off
off
4
Mode
off
DHCP Smart Mode
off
Bridge Mode, VPI=0,
VCI=35 (default settings)
on
Bridge Mode,
VPI=8, VCI=35
off
Default Unconfigured
Mode
off
ANSI
off
Multimode

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OfficeConnect 3CR414492 and is the answer not in the manual?

This manual is also suitable for:

Officeconnect 812

Table of Contents