Limited Use Of The Copier In Trouble - Konica Minolta bizhub PRO 920 Operation Manual

5
!
Detail
The administrator can call for service using the Utility setting (6
Administrator Setting>6 System Connection>1 Call Service Centre).
Refer to "7 Security Setting" on page 18-200.
In this case, you don't have to make a call for the report code, because
your machine has been monitored automatically by your service
representative.
After calling for service using the Utility setting, be sure to turn OFF the
power immediately, then unplug the machine as described here.

Limited Use of the Copier in Trouble

If the message shown below is displayed on the Call for Service Screen, you
may continue operating the copier on a limited function basis and utilize the
trays and ADU that are not affected by the trouble. To obtain this limited
functionality of the copier, consult your service representative.
Be sure to utilize the limited function only temporarily, and arrange for
machine repair immediately.
1
If the limited use of the copier is available, the following message is
displayed in the message area instead of the report code.
ex.
2
Press [Reset].
3
Turn OFF then ON the sub power switch.
A copying job can continue without using the troubled portion of the
machine (ex. Tray 2).
7 CAUTION
Limited use of the copier is completed.
% BE SURE TO CONTACT YOUR SERVICE REPRESENTATIVE
IMMEDIATELY.
5-4
-- Tray 2 failure -- Press Help
to disengage this tray
Please switch Off/On
E 18-2
Troubleshooting
bizhub PRO 920