Table of Contents
Advertisement
3.
4.
5.
6.
Troubleshooting
Turn on the equipment in the following order:
1.
2.
3.
If the output A/V device cannot be powered on, check the following:
Power Connections
1.
2.
At the
< to >
prompt, enter the IP address of the PCS4 unit. (The default IP address is
. If the address was changed in the setup or configuration process,
192.168.254.254
use the new address.) Telnet defaults to port 23.
Figure 33.
Connecting to the IP Address
If passwords were set up for the connected system, you are prompted to log in as an
administrator or a user. Otherwise, the system responds with a carriage return and line
feed (
< cr/lf >
).
Once you are connected, you can enter SIS commands as desired.
When you are finished entering commands to the interface, press < Ctrl + ] > at the
command prompt to exit Telnet.
The PCS4 power control interface
The power receptacles on the PCS4
The connected output devices
Make sure that the receptacle for each device is receiving power. The red Power LED of
the receptacle lights if the receptacle is powered on. If necessary, press the receptacle
button to apply power.
Ensure that all devices are plugged in properly to the rear panel of the PCS4 and
switched on if applicable.
IPL T PCS4 • HTML Configuration and Control
40
Advertisement
Table of Contents
