Application Diagrams - Extron electronics IP LINK IPL T PCS4 User Manual

•
•
•
•
•
•

Application Diagrams

The following application diagrams show examples of how devices can be connected to the
IPL T PCS4 in different environments.
Projector
Figure 1.
Grouping of receptacles — To support dual powered devices by controlling them
simultaneously, two or more receptacles can be grouped together. Grouping and
ungrouping can be done via the front panel, TCP ports using Simple Instruction Set
(SIS™) commands, or the internal web pages.
Detection device (alarm relay) — This relay on the rear panel can be connected to a
relay-controllable siren or other detection device, and can be programmed to react at
specified power level thresholds. The alarm relay can be configured for either normally
open or normally closed state, which activates the attached alarm device when power
drops or increases beyond a specified amount. E-mail messages can be generated based
on alarm relay conditions.
Internet communication — The PCS4 uses standard Ethernet and TCP/IP
communication protocols, including ARP (Address Resolution Protocol), DHCP (dynamic
host configuration protocol), TCP/IP (Transmission Control Protocol/Internet Protocol),
Telnet, and HyperText Transfer Protocol (HTTP).
Embedded web page serving — The IPL T PCS4 has 900 kB of internal flash memory
for storing user-customizable web pages and configuration settings. Nonproprietary
programming (HTML and JavaScript™) is available, as well as other programming
methods.
Security — Built-in multilevel security provides user control over access to devices
attached to the PCS4. Appropriate security is provided by password protection for
Administrator and User levels.
Mounting — The PCS4 can be placed on a tabletop (four rubber feet are provided
and can be attached). Optional hardware for mounting the unit under a desktop or
podium or on a rack shelf is not included, but can be ordered separately (see
Accessories" in the "Reference Material" section to order rack mounting kits).
TCP/IP
Network
Extron
2 0 V
A 0 -1
10
V 1 0
0-1 20
10
IPL T PCS4
Hz
/60
50
Power Control with
Sensing Capabilities
VOL UME
ADJ UST
DET AIL
CON T IR RN TEM 7SC
GHT RX LEA SYS
BRI NEX T LAY
TINT U DISP
COL OR MEN TX
PUT ER RX
COM
T 7
INPU IO
AUD
R
S-VID EO
O L
VIDE
M System 7SC
TRO L ROO 2
CON ROO M 7
E 1 6
P MOD
DIS E 5
DIS P MUT 4
PWR 3
2
1
Switcher
Connection Diagram for IPL T PCS4 (14 AWG Power Cord Required in US)
N
L A
M
A R
A L
Alarm
M A X
A
1 0
D
O A
L L
T A
T O
PC
DVD
"Optional
IPL T PCS4 • Introduction 2