Password Information; Error Responses; Error Response References - Extron electronics IP LINK IPL T PCS4 User Manual

Password Information

]
The
Password:
requires a password (administrator level or user level) followed by a carriage return. The
prompt is repeated if the correct password is not entered.
If the correct password is entered, the unit responds with
]
Login User
both administrator and user, the unit defaults to administrator privileges.

Error Responses

When the PCS4 receives a valid SIS command, it executes the command and sends a
response to the host device. If the PCS4 is unable to execute the command because the
command is invalid or it contains invalid parameters, it returns an error response to the host.
The error response codes and their descriptions are as follows:
E12 – Invalid port number
– Invalid value (the number is out of range/too large)
E13
– Not valid for this configuration
E14
– System timed out
E17
– Busy
E22
E24 – Privilege violation
– Device is not present
E25
– Maximum number of connections has been exceeded
E26
E27 – Invalid event number
– Bad filename or file not found
E28

Error Response References

The following superscripted numbers are used within the command descriptions in the
Command and Response table to identify commands that may respond as shown:
=
14 commands that give an
sent to an IPL product whose power configuration does not support the command.
24 = commands that give an
the administrator level.
27 = commands that may yield an
=
28 commands that may give an
prompt is displayed only if there is a password defined in the unit. It
]
, depending on the password entered. If the passwords are the same for
E14 (invalid command for this configuration) response if
(privilege violation) response if you are not logged in at
E24
(invalid event number) response.
E27
E28 (file not found) response.
]
Login Administrator
IPL T PCS4 • SIS Programming and Control
]
or
44