Table of Contents
Advertisement
Rear Panels
Figure 4.
Figure 5.
a
b
c
d
e
1
100-120V
10A
100-120V
50/60 Hz
1
IPL T PCS4 Rear Panel (120 VAC)
1
200-240V
10A
200-240V
50/60 Hz
1
IPL T PCS4i Rear Panel (220 VAC)
Power connector — Connect a power cord from the AC power supply to this male IEC
power input receptacle.
NOTE:
For the IPL T PCS4, use the supplied 14 AWG IEC power cord (part
number 27‑407‑01).
Output receptacles — Connect power cords from up to four devices to these
three-prong female U. S. (IPL T PCS4) or IEC (IPL T PCS4i) power output receptacles.
Alarm relay — Connect a relay-controllable detection device to this single-pole,
single-throw relay connector. (The default condition for this relay is normally open.)
LAN connector and LEDs — An Ethernet connection can be used on an ongoing basis
to monitor and control the PCS4 (and the devices connected to it).
RJ‑45 port — Plug a patch cable into this RJ-45 female socket,
•
and connect the other end to a network switch, hub, router,
or PC.
Link LED — This green LED lights to indicate a good network
•
connection.
Activity LED — This yellow LED blinks to indicate network
•
activity.
UID # label — Contains the unique User ID number (MAC address) of the unit (for
example,
00-05-A6-00-00-01
2
3
TOTAL LOAD 10A MAX
2
2
3
TOTAL LOAD 10A MAX
2
).
IPL T PCS4 • Installation and Rear Panel
4
S/N XXXXXXXXX E0000
0408
00-05-A6-XX-XX-XX
LAN
ALARM
3
4
4
S/N XXXXXXXXX E0000
0408
00-05-A6-XX-XX-XX
LAN
ALARM
3
4
LAN
RJ-45
Port
Link
LED
Activity
LED
5
5
5
Advertisement
Table of Contents
