Engine Top Access Covers - Rear - Winnebago Ellipse User Manual

Power Steering Fluid Reservoir
(Located in recessed area at LH side of rear
engine service access grille)
-Typical View
ENGINE TOP ACCESS COVERS
– REAR
These covers are only removed if a complete
view of the engine is needed for inspection, or for
replacement or adjustment of upper engine parts.
The engine top covers are located beneath the
rear bed and wardrobe, depending on model.
Take precautions to protect carpet and interior
furnishings when removing engine covers. The
undersides of the engine covers could contain
deposits of oil and fuel or other engine fluids and
substances that could damage fabrics and interior
furnishings.
Models with "North-South" Beds
(Lengthwise to Coach)
• Remove the mattress from the bed and set
aside in another area of the coach.
• Remove the screws that fasten the foot end of
the bed board down to the bed base.
NOTE: If bed is designed for storage below bed
board, these screws will not be present.
• Lift the hinged bed board upward against
wall. Support the bed board with a suitable
prop item as shown.
DRIVING YOUR MOTOR HOME
A falling bed board can injure. Assure the bed
is properly supported. Refer to instructions for
propping the bed board.
• Remove fasteners from metal engine covers
and set covers aside. You have now accessed
the engine.
Models with "East-West" Beds
(Crosswise to Coach)
• Remove the mattress from the bed and set
aside in another area of the coach.
• Remove the screws that fasten the foot end of
the bed board down to the bed base.
NOTE: If bed is designed for storage below bed
board, these screws will not be present.
• Lift the hinged bed board upward against
wall. Support the bed board with a suitable
prop item as shown.
A falling bed board can injure. Assure the bed
is properly supported. Refer to instructions for
propping the bed board.
• Remove the screws that fasten the wardrobe
steps beside the bed, then remove the step
cover and set aside.
• Remove fasteners from metal engine covers
and set covers aside. You have now accessed
the engine.
Removing Step Cover
When taking off the step cover, there are
screws that need to be removed. These screws
are found by feeling around the top edge of the
step cover carpet (approximately two on each
side).
SECTION 3 –
3-23