Winterizing Procedure - Winnebago Ellipse User Manual

Hide thumbs Also See for Ellipse:
Table of Contents

Advertisement

SECTION 7 –
PLUMBING

WINTERIZING PROCEDURE

NOTICE
Do not blow out Aqua-Hot Hydronic
Heating System. Failure to comply may
result in system damage.
Antifreeze Fill Procedure
(Fill plumbing lines with RV water system
antifreeze)
NOTE: Winterize tanks and waterlines by filling
them with non-toxic RV water system
antifreeze through the plumbing system.
This product is available from your
dealer and from most RV supply stores
and national retail outlets. Follow
directions on the container to determine
the correct amount to use for your coach.
Your coach is equipped with a manually
operated waterline winterization system for your
convenience in winterizing fresh waterlines.
The system features a winterization (diverter)
valve with siphon tube to draw non-toxic RV
water system antifreeze into the waterlines. This
feature is located near the water pump.
WARNING
NEVER use automotive antifreeze/
coolant in your RV water system. Auto
antifreeze contains ethylene glycol which,
if ingested, can cause blindness and can
be fatal.
Remove Water Filters (if equipped)
1. Remove and discard the filter cartridge from
the filtered water faucet/ice maker filter
assembly below the galley sink.
(If your coach is not equipped with a filtered
water faucet or ice maker, proceed to the next
numbered step).
7-14
Water Filter Assembly
(Located below galley sink)
Twist the filter cartridge counter-clockwise
(left) about a quarter-turn and pull it down and
out of the filter socket.
NOTE: The water filter head has a built-in
bypass. No separate diverter plug is
needed.
2. Remove the filter canister from the full-coach
water filtration system in the water center
compartment (if equipped) and discard the
filter cartridge.
(If your coach is not equipped with a full-
coach water filtration system, proceed to the
next numbered step).
After removing filter, remount the empty
canister onto the filter assembly and continue
the antifreeze fill procedure.
3. Place handle of Winterization Valve 2 in the
"Winterize" position.

Advertisement

Table of Contents
loading

Table of Contents