Inverter/Charger Unit - 2800W (Pure Sine Wave) - Winnebago Ellipse User Manual

Power Cord Reel
(Located inside an exterior compartment)
-Typical View
To Extend the Power Cord
• Pull out power cord (manually) to a sufficient
length and route power cord to an electrical
receptacle and plug in.
To Retract the Power Cord
• Detach plug from receptacle using the lever
on plug.
• PRESS and HOLD the Power Cord Reel
Switch (located near the power cord reel) and
the power cord will retract automatically.
Power Cord Reel Switch
(Located near the power cord reel)
-Typical View
Further Information
See the manufacturer's user guide provided in
your InfoCase for complete features, operating
instructions, and precautions.
INVERTER/CHARGER UNIT –
2800W (PURE SINE WAVE)
–If Equipped
(For models equipped with Residential-
Style Refrigerator)
The 2800-watt inverter/charger has an AC
input circuit breaker to protect the inverter/
charger from overloads. The inverter/charger
also has "built in" features that protect the system
from abnormal conditions. See the inverter/
charger information included in your InfoCase
for a complete explanation of the system and
operating instructions.
NOTE: The inverter is not intended for steady
use while "dry camping". Batteries will
deplete quickly with use of the inverter.
The inverter is intended for limited, short
term power usage when not connected to
shoreline or generator power.
The inverter can also be used while
driving the motor home because the
engine alternator will charge the
batteries while driving.
The inverter/charger unit is accessible through
a mid-passenger side compartment door.
Inverter Charger Unit
(Accessible through mid-passenger
side compartment door)
-Typical Installation
SECTION 6 –
ELECTRICAL
6-3