Power Roof Ventilator - Galley - Winnebago Ellipse User Manual

SECTION 12 –
MISCELLANEOUS
Vertical Window Catches
POWER ROOF VENTILATOR –
GALLEY
–If Equipped
The 3-speed turbine vent is controlled by a
switch on the wall to raise or lower the dome.
The turbine fan will start automatically as the
vent is raised, and stop as the vent is lowered.
A thermostat near the OnePlace
panel can also be set to automatically open and
close the vent at a selected temperature.
Fan Power
Fuse
Switch
Power Ventilator
-Typical View
12-10
To Operate Ceiling Ventilator
1. Press the wall switch to raise the dome about
2. The turbine fan will start automatically as the
3. Turn the Fan Speed knob to the desired level
4. Open a window or door to provide airflow.
NOTE: For best results, close all other roof
®
monitor
5. If you want the vent dome raised without the
Fan Speed
Selector
NOTE:In event of power failure the ventilator
Ventilator Thermostat
-If Equipped
which you want the ventilator to open
automatically and exhaust room air.
temp selector lever to the OFF position.
Dome Crank
3" or more to allow the turbine fan to operate.
(A built-in safety switch will not let the fan
motor run unless the dome is partially open).
vent dome is raised and stop as the vent dome
is lowered and closed. (Fan Power switch
must be ON and Fan Speed knob in a position
other than 0-Off.)
(1-Low, 2-Med, 3-Hi).
Direction of airflow is determined by which
window or door is opened.
vents, windows, and doors, then open
one (1) window the farthest distance
from the roof ventilator. The fan speed
selector on the ventilator allows you to
control the amount of circulation you
need at any time.
fan running, turn Off either the Fan Power
switch or Fan Speed knob (0-Off ).
dome may be opened or closed manually
using the Dome Crank knob.
The thermostat lets you set a temperature at
This function can be disabled by sliding the