Table of Contents
Advertisement
SECTION 3 –
DRIVING YOUR MOTOR HOME
Set (Set Speed/Coast)
•
Press to maintain current desired driving
speed. Will not work below 40 mph.
•
This button will also perform "Coast" feature.
Press and hold until vehicle slows to desired
speed and release to establish new "set"
speed.
Res (Resume/Accel)
•
Press to return to previous "set" speed after
braking or reducing speed.
Cancel
•
Press to switch cruise function off without
losing current "set" speed.
WARNING
Do not operate the cruise control on icy or
extremely wet roads, winding roads, in
heavy traffic, or in any other traffic
situation where a constant speed cannot
be maintained.
Wiper Functions
There are four wiper control buttons:
•
Wiper On - HI/LO
•
Wiper Off
•
Wiper Delay
•
Wash/Wipe
3-18
NOTE: Many states now have laws that require
headlights to be on during precipitation
conditions. To assure compliance with
this law, the headlights will come on
whenever you press any of the wiper
function buttons - Hi/Lo, Wash, or Delay.
Headlights will turn off when the ignition
switch is turned off.
Wiper On - Hi/Lo
•
Press to turn wipers on at Lo speed;
•
then press again to switch wiper speed back
and forth from Lo to Hi speed.
•
Press Off button to switch wipers off.
Wiper Off
•
Press to shut wipers off.
•
Wipers will also switch off when the ignition
is turned off.
Wiper Delay
This switch will set a Lo speed wiper delay time
based on the duration between any two presses
of the button.
How it works:
•
During a light rain or mist, when your
windshield needs a clearing wipe, press the
button once and the wiper will swipe back and
forth once at Lo speed. Let's say 7 seconds
later, the windshield needs another wipe -
press the button again and the delay time will
be set to 7 seconds.
•
If the mist gets heavier and you press the
button again 3 seconds after the last wipe, the
delay time will be reset to 3 seconds.
•
The delay time can be set from approximately
1 to 30 seconds.
Wash/Wipe
•
Press switch to activate Lo wipers and spray
washer fluid onto the windshield for as long as
you hold the button.
•
After you release the button, the wipers will
continue for three wipe cycles, then turn off.
Advertisement
Table of Contents
