Operation Warnings And Cautions - Winnebago Ellipse User Manual

Control Pad, the dash instrument panel,
or on the Generator itself, depending on
model.
Generator Hourmeter
The Generator Hourmeter is located on the
AGS Control Pad. It registers the total number of
hours that the Generator has been operated. Press
the "Up/Down" button to scroll to desired screen
for Generator Hourmeter reading.
Refer to the Hourmeter to determine when
periodic maintenance is due and to record
services which have been performed.

Operation Warnings and Cautions

WARNING
The exhaust of all internal combustion
engines contains carbon monoxide (CO).
This poisonous gas is colorless, odorless,
tasteless, and lighter than air. The
exhaust systems of both your motor home
engine and your generator engine have
been installed with your safety in mind.
However, certain precautions must be
taken when using them to protect yourself
from conditions beyond the control of the
manufacturer.
• Do not simultaneously operate the Generator
and a power vent, which could draw exhaust
gases into the vehicle.
• Do not open windows or vents on the end or
side of the vehicle where exhaust pipe of the
Generator is located.
• Park the vehicle so that the wind will carry the
exhaust away from the vehicle. Also, note the
position of other vehicles to be sure their
exhaust will not enter your vehicle.
• Do not operate the Generator engine while
parked if vegetation, snow, buildings,
vehicles, or any other object can deflect the
exhaust under or into the vehicle.
Check Generator oil level frequently during
periods of use. Refer to the Generator
manufacturer's user guide provided in your
InfoCase for specific recommendations.
Generator Access
The Generator is located behind the front
hood, mounted on a pull-out tray.
To Pull Front Hood Panel Out
1. Pull Release Lever straight out (toward front
end of coach) and extend hood.
Release Lever
(Located underneath the
passenger side front hood)
NOTE: As a safety feature, the hood will only
extend partially after disengaging the
Release lever. Continue with Step 2 for
full extension procedure.
2. Lift Security T-Pin straight UP while
simultaneously pulling hood out to the fully
extended position.
SECTION 6 –
ELECTRICAL
6-9