Tv (Bedroom) - Power Lift - Winnebago Ellipse User Manual

Hide thumbs Also See for Ellipse:
Table of Contents

Advertisement

Antenna
Turn On antenna booster
inside coach.
Turn On TV and tune to
desired channel.
Cable
(Park cable input located in power cord
compartment)
Turn Off antenna booster inside coach. See
above photo.
Turn On TV and tune to desired channel.
Video Programming from the Video
Selection Box
Turn On video
selection box and
select desired input
(Satellite, DVD, or
Aux) for TV2.
Turn On TV and press the SOURCE or
INPUT button on the TV or TV remote to
select INPUT1 or AV1.
Play TV Through Stereo Speakers
The exterior entertainment center TV is
connected to the video selection box, the rooftop
antenna, and the park cable input. To play this
signal through the stereo speakers:
Tune TV to desired channel or input.
Turn On the radio and press the MODE button
on the remote or the radio until it displays AV-
IN1.
Adjust the volume on the TV or the radio for
desired level.
Further Information
For further information and operating
instructions, see the manufacturer's information
included in your InfoCase.

TV (BEDROOM) - POWER LIFT

–If Equipped
Your coach may be equipped with a bedroom
TV power lift/lower mechanism, which allows
you to raise and lower the TV with a touch of a
switch.
There are two control switches equipped with
this feature - one located near the TV and the
other mounted on the bedroom nightstand.
The TV is not intended for use while the
vehicle is in motion. Road vibration may damage
the TV and/or power lift mechanism in the
extended position.
The following label is located near the TV.
1. To raise the TV, press the control switch UP
and the TV will pop up through the access lid.
Power Lift/Lower Control Switch
-Typical View
2. Raise TV to the height that best suits your
viewing needs.
SECTION 8 –
ENTERTAINMENT
8-5

Advertisement

Table of Contents
loading

Table of Contents