Hazard Warning Flashers - Winnebago Ellipse User Manual

Tag Axle Switch
(Located on the driver side trim panel)
-Typical View
Tag Axle Switch Operation
Tag Dump Position
• Press and Hold switch in the TAG DUMP
position for the Tag Axle air pressure to
remain reduced and maintain the
maneuverability or traction benefit desired.
Auto Dump Position
• This mode is activated automatically when in
reverse gear, when the Tag Axle switch is in
the MIDDLE position. The Auto Dump
feature gives you better maneuverability
while driving in reverse.
Off Position
• The Tag Dump mode is inactive when the Tag
Axle switch is in the OFF position.
NOTE: If an override event occurs while the
switch is held in the Tag Dump position,
the switch must be cycled on and off to
clear the override command.
Further Information
See the chassis manual provided in your
InfoCase for more information and precautions
on using this feature.
DRIVING YOUR MOTOR HOME

HAZARD WARNING FLASHERS

The hazard warning flashers provide
additional safety when the vehicle must be
stopped on the side of the roadway and presents a
possible hazard to other motorists. When the
flashers are on, it serves as a warning to other
drivers.
NOTE: Move multi-function lever up or down to
cancel.
Further Information
See the chassis manual in your InfoCase for
instructions on activating, operating, and
canceling hazard warning flashers.
SECTION 3 –
3-15