Table of Contents
Advertisement
SECTION 3 –
DRIVING YOUR MOTOR HOME
Keyless Entry Remote
-Typical View
Reprogramming Remote
When replacing batteries, the remote unit may
need to be reprogrammed with a switch on the
keyless entry system control box.
The entry system control box is located
behind the circuit breaker mounting panel in the
12-volt electrical compartment at the front left
side of the coach.
To access the keyless entry control box,
remove four screws and open the panel carefully
to avoid damage or disconnection of wiring
looms.
Keyless Entry Control Box
(Located in 12-volt electrical compartment)
-Typical View
The programming switch is protected by a
sealing label as indicated on the box.
See the Keyless Entry System operating guide
in your InfoCase for programming sequence.
3-6
Further Information
Please read the Keyless Entry System
information in your InfoCase for a full
description of all system features.
MIRRORS – POWER ELECTRIC
Always adjust mirrors for maximum rear
visibility before driving. Make sure the seat is
adjusted for proper vehicle control and that you
are sitting back squarely into the seat.
Mirror Adjustment Control
The mirror control is mounted along sidewall
below driver side window. The ignition key must
be on to adjust the mirrors.
Advertisement
Table of Contents
