Chassis Battery Disconnect Switch; Circuit Breakers And Fuses - Chassis/Dash Automotive 12-Volt - Winnebago Ellipse User Manual

Hide thumbs Also See for Ellipse:
Table of Contents

Advertisement

SECTION 3 –
DRIVING YOUR MOTOR HOME
NOTICE
When refilling the coolant system of a
vehicle equipped with a rear auxiliary
automotive heater and motoraid water
heater, be sure to allow for additional
coolant capacity of the heater and its
supply and return hoses.
Further Information
Refer to the chassis manual in your InfoCase
for information and precautions on filling,
servicing, and checking the fluid level.
CHASSIS BATTERY
DISCONNECT SWITCH
The Chassis Battery Disconnect switch
disconnects most chassis electrical loads from
the chassis (starting) batteries to avoid discharge
by constant draws such as engine computers,
radio clock, sensors, etc. (except the electric
entrance step). This feature is intended to help
conserve battery charge during storage.

Chassis Battery Disconnect Switch

(Located near entrance door)
-Typical View
Turn the switch to the OFF or ON positions to
disconnect or reconnect the chassis batteries.
3-28
NOTE: The Chassis Battery Disconnect switch
must be on to start the engine.
CIRCUIT BREAKERS AND
FUSES – CHASSIS/DASH
AUTOMOTIVE 12-VOLT
The fuses, breakers, and relays for automotive
chassis and dash features are conveniently
located on the main 12-volt electrical panel in the
front left exterior compartment.
The circuit breakers pop outward if they are
tripped. Simply push in to reset.
12-Volt Automotive
Fuse Panel
12-Volt Automotive Breaker Panel
Automotive Circuit Breakers (push to reset)
• Breakers are labeled for components equipped

Advertisement

Table of Contents
loading

Table of Contents