Mirrors - Power Electric - Winnebago Journey 34Y Owner's Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
NOTE:Keys should always be removed when
leaving the vehicle. Since doors can be
locked without keys, make sure they have
been removed from the ignition before
locking the coach.
Reprogramming Remote
When replacing batteries, the remote unit may
need to be reprogrammed with a switch on the
keyless entry system control box.
The entry system control box is located
behind the circuit breaker mounting panel in the
12-volt electrical compartment at the front left
side of the coach.
To access the keyless entry control box,
remove four screws and open the panel carefully
to avoid damage or disconnection of wiring
looms.
Keyless Entry Control Box
(Located in 12-volt electrical compartment)
-Typical View
The programming switch is protected by a
sealing label as indicated on the box.
Further Information
Refer to the Keyless Entry System
information provided in your InfoCase for
complete operating information as well as a full
description of all of the system's features and
programming instructions.
3-6
MIRRORS – POWER ELECTRIC
Always adjust mirrors for maximum rear
visibility before driving. Make sure the seat is
adjusted for proper vehicle control and that you
are sitting back squarely into the seat.
Turn Signal Indicator Lights
-If Equipped
Your coach may be equipped with turn signal
indicators, which are built into the driver and
passenger side mirror arms. The indicators are
activated with the corresponding turn signals and
will remain activated until the turn is completed
or the signal lever is canceled manually.
Mirror Adjustment Control
The mirror control is located on the driver side
armrest panel or the dash. The ignition key must
be on to adjust the mirrors.