Table of Contents
Advertisement
To view the router's power source information, log in to the router and expand the Advanced status box on the status page. See
the
Status
section of this manual for more information on the status page.
Power consumption
To assist with power consumption planning, the following table summarises average power consumption during the various states
of the NTC-6200 Series router under normal usage conditions. It's important to note that this table serves as an indication only as
the power consumed by the device is affected by many variables including signal strength, network type, and network activity.
Average power consumption figures
Powering up, inrush power
Powered on, idle and connected to packet data
Powered on, connected to packet data with average
load
Powered on, connected to packet data with heavy traffic
Peak power draw at maximum 3G module transmission
power
Installing the router
After you have mounted the router and connected a power source, follow these steps to complete the installation process.
1.
Connect equipment that requires network access to the Ethernet port of your router. This may be your computer for
advanced configuration purposes, or your end equipment which requires data access via the NTC-6200 Series router. You
can connect one device directly, or several devices using a network switch.
If you're using PoE as the power source, you need to connect any devices via an available data Ethernet port on your PoE
power source (be it a PoE network switch or PoE power injector).
2.
Ensure the external power source is switched on and wait 2 minutes for your NTC-6200 Series router to start up. To
check the status of your router, compare the LED indicators on the device with those listed in the
this guide.
NetComm Wireless 3G M2M Router / Plus
18
STATE
Table 11 - Average power consumption figures
POWER CONSUMPTION
6.0W
1.2W
2.0W
4.0W
5.0W
LED Indicators
www.netcommwireless.com
section of
Advertisement
Table of Contents
