Table of Contents
Advertisement
To create an endpoint:
1.
Click the +Add button on the right side of the page. A pop-up window appears.
2.
In the Endpoint name field, type a name for this endpoint. The name can contain alphanumeric characters only i.e. A-Z, a-
z, 0-9.
3.
Use the Endpoint types drop down list to select the type of endpoint to configure.
Serial port (generic): When a USB to Serial cable is used, this creates a generic serial port as an endpoint defaulting to the
commonly used settings as shown below.
When the Host port is set to Custom, you can use the Custom host port name field to manually specify a device path to
use, for example, if using a USB-to-Serial adapter you could telnet to the router and issue the command ls
/dev/ttyUSB* to list the paths of the connected USB devices. To determine the path of the desired USB adapter, issue
the command when the adapter is not connected then run the command again when the adapter is connected and
compare the output.
Note: Using a custom host port name is not recommended for normal use as the device path can change between power
cycles of the router.
NetComm Wireless 3G M2M Router / Plus
68
Figure 75 - Creating an endpoint
Figure 76 - Serial port (generic) endpoint configuration
Figure 77 - Serial port (generic) endpoint configuration (Custom)
www.netcommwireless.com
Advertisement
Table of Contents
